300 RD Enamel
rapid drying industrial spraying enamel based on co-polymer alkyd resins.
Description and uses:
300 RD Enamel is a rapid drying industrial enamel based on co- polymer alkyd resins, for the protection of metal surfaces in light industrial environments.
300 RD Enamel has the following features:
• Extremely fast drying and setup.
• Excellent recoating properties.
• High gloss and moderate exterior durability.
Typical areas of application are:
• Machinery, cabinets, furniture etc.
• Bridges, pylons, tanks etc.
• Electronic equipment housings.
• Earthmoving and materials handling equipment.
Technical Specifications:
FINISH: High Gloss.
THINNERS: T102 or (T124 for electrostatic application).
VOLUME SOLIDS: 35% – 40% depending on colour.
VOC: 485 gms/litre. (White).
COVERAGE: 9 – 11 Square metres per litre (at a D.F.T. of 40 microns).
RECOMMENDED FILM THICKNESS: 30 – 40 microns.
APPLICATION: Conventional or Airless Spray.
DRYING AT 25’C / 50% Humidity:
- Touch dry: 15 minutes
- Recoat: 2 hours
- Hard dry: Overnight.
Surface Preparation:
• When overcoating; Aged paint coatings should be tested for adhesion using Crosshatch or Crosscut methods. If aged paint coating lifts remove it.
• Remove all rust, oxides, millscale and lose paint from metal surface.
• Round off all sharp edges, welding joints and weld spatter.
• All surfaces to be painted should be clean and free from dust, dirt, oil, grease and moisture.
• All abrasive blast clean ferrous surfaces should be coated within 4 hours to avoid flash rusting.
• Do not apply at temperatures below 5’ Celsius. Do not apply at relative humidity above 85%, or when the substrate surface is less than 3’ Celsius above dewpoint.
Product specification sheet
300 RD Enamel product specification sheet opens in a new windowManufacturer
Lacnam
