310 Enamel

economical modified alkyd spraying enamel.

Description and uses:

310 Enamel is economical modified alkyd spraying enamel for use in light industrial environments, where top quality exterior durability is not required.

310 Enamel has the following features:

• Fast drying and setup

• Excellent recoat properties

• Tough film properties

• Extensive colour range

Typical areas of application are:

• Tools, machinery, pipelines, etc

• Structural steel and sheet metal

• Drums, trailers, etc

Technical Specifications:

FINISH: High Gloss.
THINNERS: T102 or T104 (or T124 for electrostatic application).
VOLUME SOLIDS: 39 – 42% depending on colour.
VOC: 490gms/litre. (White).
COVERAGE: 9-10 Square metres per litre (at a DFT of 40 microns).
RECOMMENDED FILM THICKNESS: 25 – 45 microns DFT.
APPLICATION: Conventional or Airless Spray.
DRYING AT 25’C / 50% Humidity:

• Touch dry: 20 – 30 minutes
• Recoat: 2 Hours
• Hard dry: Overnight.

Surface Preparation:

• When overcoating; Aged paint coatings should be tested for adhesion using
  Crosshatch or Crosscut methods. If aged paint coating lifts remove it.
• Remove all rust, oxides, millscale and lose paint from metal surface.
• Round off all sharp edges, welding joints and weld spatter.
• All surfaces to be painted should be clean and free from dust, dirt, oil, grease and
  moisture.
• All abrasive blast clean ferrous surfaces should be coated within 4 hours to avoid
  flash rusting.
• Do not apply at temperatures below 5’ Celsius. Do not apply at relative humidity
  above 85%, or when the substrate surface is less than 3’ Celsius above dewpoint.

Equipment Application: (Conventional or Airless Spray Recommended).As a Guide Use:

• Brush or Roller – Suitable for small areas only, additional coats may be required to
  achieve specific film build.
• Conventional Spray – 1.3 -2.0mm tip (or equivalent). Pressure pot set at 55 – 100kpa
  (8 – 15psi) and maintain gun air pressure 275 – 380kpa (40 -55psi).
• Airless Spray – Use heavy-duty airless spray with 10 -15 “(0.25 – 0.38mm) plus tip and pump ratio 30:1.

Product specification sheet

Manufacturer

Lacnam

Lacnam is a leading industrial paint supplier to wholesalers, manufacturers, government and private sector clients. Lacnam Paints Australia is a successful paint manufacturer that develops and produces specialized liquid paint coatings for industrial and heavy duty application.