GP Primer
Waterbased, fast drying, single pack primer.
This water-based, fast-drying, single-pack primer is for wet-area waterproofing using Flowthane, Ultra Flex, or Resinflow P96-certified waterproofing membranes.
The product establishes a strong key to properly prepared substrates, thereby enabling good adhesion of the overlaying membrane. It is water-based and contains no solvents or other harmful ingredients. Though the product is non-hazardous, it is good practice to avoid contact with skin and eyes. If eyes are contaminated, rinse immediately with clean water and seek medical assistance.
The product is not recommended as a priming source for areas where trafficable membranes, such as Ultra Flex Traffic, are to be applied. For these types of applications and in any situations where there is doubt about the substrate suitability or soundness, applicators are advised to use Resinflow’s two-pack, water-based Hydro Static Epoxy to stabilize poor substrates and ensure good adhesion.
Advantages
Fast drying with strong adhesion properties, economical, non-hazardous, with very good adhesion characteristics to concrete.
Uses
As a primer for wet area waterproofing using Resinflow Flowthane, P96 and Ultra Flex wet area membranes. Resinflow GP Primer is suitable for priming on concrete, masonry, concrete blocks, plasterboard, aerated concrete, Scyon, fibre cement sheeting, yellow tongue timber and compressed fibre sheeting.
Typical Performance Characteristics
Colour – Fluorescent Green
Drying time – Touch 5 minutes (25°C, 65% RH)
Membrane application – As soon as the adhesion promoter is touch dry
Flash point – Not applicable
Coverage – 10-12 m/litre Depending on application method and substrate porosity/condition
Packaging – 15 and 5 litre pails. Bulk packaging is available
Product specification sheet
GP Primer product specification sheet opens in a new windowManufacturer
Australian Membrane Industries Sydney
